Build your animation clip by clip.
Click a clip to select it. Drag a divider to retime the pair, drag a clip body sideways to reorder. Space toggles playback. A yellow marker on a divider means the two clips don't meet cleanly — see the note under Motion.
Only works on flat single-colour backgrounds.
With this on, the logo sits dead centre on its own and only moves across (or up) as the text or second image is revealed.
Lightning, Storm and Thunder strike from the top of the frame into the logo; Electric crawls sparks around it. Set more repeats for more strikes.
Entrances start off-screen and finish neutral. Loops are neutral at both ends so they repeat cleanly. Exits start neutral and end off-screen. Put them in any order — an exit followed by an entrance is a valid re-entry. The timeline flags a divider in yellow whenever two neighbours don't meet.
Timings are a percentage of the whole sequence. The text hides during entrance clips and leaves with exit clips.
The entrance plays at "Starts at" (a percentage of the whole sequence). The loop runs underneath from then on, and the exit plays on top during the logo's exit clip — "Same as the logo" copies whichever exit that clip uses, Fold, Spin, Close or anything else. Lightning loops strike this image instead of the logo. It stays hidden during the logo's entrance clips.
Glued to the logo: it enters, loops and exits with every clip exactly as the logo does, as one lockup.
The image uses the same trim and background-removal settings as the logo.
Timed inside this clip, not the whole sequence.
Follows the clip: sharpens across an entrance, softens across an exit, stays sharp on a loop.
Cross-fades effect settings across each divider so they don't pop. This one setting applies to the whole sequence.